Computer & Electronic Services

Cowlacious DesignsTM

Hauntingly Good Electronic Products!TM

PET OEM Model Details

PET-III-R2-OEM and Vari-PET-R2-OEM (shown above) with standard switches. The circuit can also be powered by a 9-24VDC power supply, optional 6V battery pack, or optional wall transformer. It also has mounting holes in the four corners of the main board to make it easier for the OEM to install the unit into their creation.

Technical Specifications:

Board Size of PET-OEM: L x W x H - 2.85in.(72.4mm) x 2.27in.(57.7mm) x 1.0in.(25.4mm). Please note that the height measurement is the minimum height this unit is available in. Standard configuration with LEDs on risers, makes the height 1.3in (33mm). Other options, such as the need for a heat sink on the voltage regulator, may increase the length of the unit.

Relays: 2 SPDT w/ contacts rated at 240VAC / 28VDC, 8A.

Terminal Blocks: Rated voltage - 250V. Rated Current - 15A. Wire Size - 14-22 AWG. Insulating Material - polyimide. Terminal block - copper zinc. Wire guard - copper nickel.

Trigger Switch Contact Wetting: 15mA of current is provided to wet the contacts of the trigger source, which should be more than adequate in most instances. If the switch in the triggering device you plan to use with the PET requires more current than that, then please specify how much current you need.

 

Send mail to support@cowlacious.com with questions or comments about this web site.
Copyright © 2004 Computer & Electronic Services
Last modified: 09/26/07